Driveshaft Order Form
American Powertrain Driveshaft Order Form & Pinion Angle Guide
-
- IMPORTANT: PLEASE MAKE SURE TO READ THOROUGHLY U-Joint Measurement: Measure the overall width of your rear u-joint and the diameter of the joint cap. If you do not have the u-joint you can measure where the u-joint seats in the differential yoke. 1310, 1330 and 1350 joints are typical of GM and Ford differentials. The 3R is a GM joint identified by inside C-clips rather than outside G-clips. 7260 and 7290 are Mopar joints with inside clips. The 1330S is only found in Fords.
- Any relevant comments, questions or notes about your driveshaft and install
- This field is for validation purposes and should be left unchanged.